Engineering Drawing Mock Test 2

10%

Question 1 of 10

1. The leader in dimensioning is drawn __________

with a convenient angle (>30°)

curved

vertical

horizontal

Question 1 of 10

Question 2 of 10

2. The wrong statement about leader line is _____________

The leader is drawn vertical or horizontal or curved.

Use of common leaders for more than one feature should never be made.

One end of the leader terminates either in an arrowhead or a dot.

A leader line is a thin continuous line connecting a note or a dimension figure.

Question 2 of 10

Question 3 of 10

3. Which type of dimensioning is shown in the figure?

Chain Dimension

Unidirectional dimension

Combined dimension

Parallel dimension

Question 3 of 10

Question 4 of 10

4. Identify the ‘a’ in the below given picture.

leader

extension line

outline

dimension line

Question 4 of 10

Question 5 of 10

5. What is not essential information to construct a scale from the following?

Maximum length

Length of scale

The R.F. of the scale

The units to represent

Question 5 of 10

Question 6 of 10

6. What is the representative factor of a line, whose length is 24cm on the drawing sheet, representing an actual length of 6m?

1:25

1:60

1:24

1:50

Question 6 of 10

Question 7 of 10

7. The length of the drawing is 50 mm, the scale is given as 1:5. Find the actual length.

10 cm

50 cm

10 mm

25 cm

Question 7 of 10

Question 8 of 10

8. The scale used to find angles is ________

Circular vernier scale

Comparative scale

Diagonal scale

Scale of chords

Question 8 of 10

Question 9 of 10

9. Which of the following is used in checking the instruments to measure angles with great accuracy?

Plain scale