Energy Engineering Online Test

1. At what type of location vibrations are more in the wind turbine?

2. What is Ethanol called?

3. Which of these is a stationary boiler?

4. Which fuels are either natural or artificial fuels?

5. What is used in conversion of sunlight energy into usable chemical energy in plants?

6. Which of the turbine can be mounted vertically and horizontally?

7. Which plants are used with steam and IC engines?

8. At what type of location vibrations are less in the wind turbines?

9. Which is the process from which heat for distillation comes, in under feed system?

10. Chances of sediments depositing inside the water tubes in the shell is less due to?

11. What is CRDi?

12. Which type of generator are made use in wind turbines?

13. Which type of fuel is removed from the reactor core after reaching end of core life service?

14. In what manner is the coal is fed to all the burners in pulverized fuel system?

15. What is the factor on which, difference between the two heating values of fuel depends on?

16. How is biogas from an anaerobic digester collected?

17. In which state would be the soot blower when it’s not in use?

18. What does ADF stand for in hydrology?

19. Which calorimeter is used to find calorific values of gaseous fuels?

20. Water _________ decreases with an increase in temperature.

21. Angular distance of sun’s rays north or south of the equator is called _______

22. Water gets polluted by submerged vegetation mineral.

23. What are released into biosphere from nuclear power plants?

24. Which types of plants are filled and then emptied completely after fixed retention time?

25. other than Steam stop valve in the boiler which is the other similar type of valve used?

26. What is the main disadvantage of Lamont boiler?

27. What type of energy does rain falling holds relative to the oceans?

28. A continuous movement of water in specific direction is called as _________

29. Which type of oil burners are commonly used in oil-fired furnaces of steam generators?

30. How is height of wave determined?

31. How much is the energy available in the winds over the earth surface is estimated to be?

32. Why are the blades of shaft in spreader stoker twisted?

33. Which fuel is prepared by heating bituminous coal continuously for 15 to 18 hours in closed chamber?

34. Which type of weighers is used in place where the electronic weighers are not allowed?

35. Why neutrons with lower energy should be capable of causing fission?

36. In which coal burners are fuel and air streams ejected in horizontal direction?

37. Which medium is used to carry ash in the pneumatic ash handling system?

38. What type of boiler is a Benson boiler?

39. How many level indicators are there in the water level indicator of a boiler?

40. How many weeks does a batch digester need to produce biogas?

41. How is water pumped into condenser tubes in the steam power plant?

42. Which type of boilers are called drum-less boilers?

43. How is flue gas discharged through the chimneys?

44. Which fuel has higher calorific value among given fuels?

45. Which plant has fixed hemi-spherical roof?

46. Why blade velocity of wind turbine varies?

47. In which type of lubrication method are splash rods used?

48. How is High Level solidified nuclear wastes (HLW) stored?

49. In which switch position are all circuits open?

50. Determine the pondage factor if the plant is working at peak time of 16 hrs?